Symbol Spectrum24

NOTE: This guide is only useful if the default system password has not been changed.

  1. Start the console session.

    Plug in serial cable to console port of device from PC COM1 port
    Open PuTTY and select "Serial" connection type, change baud rate (Speed) to 19200 and leave other settings as default.
    Plug power into device and if a power button exists, turn it on.

  2. Gain elevated access to the Special Functions menu.

    Navigate the MAIN MENU using the up/down arrow keys to "Enter Admin Mode" and press Enter:
    ATZ Booting Access Point ... MAIN MENU Show System Summary AP Installation Show Interface Statistics Special Functions Show Forwarding Counts Set System Configuration Show Mobile Units Set RF Configuration Show Known APs Set Access Control List Show Ethernet Statistics Set Address Filtering Show RF Statistics Set Type Filtering Show Misc. Statistics Set SNMP Configuration Show Event History Set Event Logging Configuration Enter Admin Mode Set Authorized AP Configuration
    Type Symbol for the system password:
    Enter System Password: Symbol
    Navigate to "Special Functions" and press Enter:
    MAIN MENU Show System Summary AP Installation Show Interface Statistics Special Functions Show Forwarding Counts Set System Configuration Show Mobile Units Set RF Configuration Show Known APs Set Access Control List Show Ethernet Statistics Set Address Filtering Show RF Statistics Set Type Filtering Show Misc. Statistics Set SNMP Configuration Show Event History Set Event Logging Configuration Exit Admin Mode Set Authorized AP Configuration

  3. Erase configuration.

    Navigate the Special Functions Menu to "Restore Factory Config." and press Enter. Confirm by selecting yes and press Enter again.
    Special Functions Menu Clear All Statistics Restore Factory Config. Clear MU Table Save Configuration Clear ACL Save Config. to All APs Clear Address Filters Clear Type Filters Firmware Update Menu-[F3] Clear Authorized AP List AirBEAM Configuration Load ACL from File via TFTP Load ACL from File via XMODEM Load ACL from MU List Reset AP Configure Network Time Security Configuration: Configure Authentication and Encryption Configure Kerberos Configure EAP Are You Sure? yes no ATZ Booting Access Point ...
    Ensure the system reboots successfully.

  4. Copy all the output from the session into your records.

    Right-click PuTTY's titlebar, from that dropdown menu click on "Copy All to Clipboard"
    Open the file of record certifying the deconfiguration of this device and use CTRL V to paste all the output from PuTTY into that file. Formatting the text with a fixed-width font helps it look more readable.

  5. End the session.

    Close PuTTy.