RADWARE DefensePro 904674

  1. Start the console session.

    Plug in serial cable to device from PC COM1 port
    Open PuTTY and select "Serial" connection type, change baud rate (Speed) to 19200 and leave other settings as default.
    Plug power into device and if a power button exists, turn it on.
  2. Interrupt boot sequence.

    Press any key when prompted to stop auto-boot, and before the countdown ends.
    cm:/ - Volume is OK CPU: Cougar 7410 Cougar HW version:3.20 DRAM size: 256M Flash size: 8M BSP version: Boot 5.30 Creation date: Aug 4 2004, 14:14:45 Press any key to stop auto-boot... 1
    This will bring you to the >  prompt.
  3. Erase configuration and reboot

    Type q1 at the prompt:
    > q1 Erasing configuration ... Erasing Network Section ... fl:/ - Volume is OK done
    Type @ at the prompt:
    > @ Attaching to memory device... cm:/ - Volume is OK done. Loading cm:/dp-1.32.05/master/Cod110561072 fl:/ - Volume is OK Starting at 0x10000... Attaching interface lo0...done
  4. Copy all the output from the session into your records.

    Right-click PuTTY's titlebar, from that dropdown menu click on "Copy All to Clipboard"
    Open the file of record certifying the deconfiguration of this device and use CTRL V to paste all the output from PuTTY into that file. Formatting the text with a fixed-width font helps it look more readable.
  5. End the session.

    Turn off/unplug the device and close PuTTy.